SPB 2600 C2
■ 14
│
GB
NOTE
► Alternatively, you can also use the original
charging cable (USB cable) provided by the
respective device manufacturer.
♦ During the charging process, the current charge
level of the Power Bank is shown via the charge
level LEDs
(see table in chapter entitled
“Charging the Power Bank”).
♦ To end the charging procedure, disconnect the
charging cable
from the mobile device and
the Power Bank. The charging status LEDs go
off after about 30 seconds.
Troubleshooting
The Power Bank does not charge
♦ Connection may be faulty. Check the connection.
♦ Some computers deactivate the power supply to
the USB ports when they are switched off. Check
that the computer is switched on.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
to start the charging
process.
To Next Page
Loading...
