Silvercrest SPB 3000 A1 - Charging the Power Bank

SPB 3000 A1
GB
│
IE
│
NI
│
11 ■
Charging the Power Bank
Before using the Power Bank, the integrated battery
must be fully charged.
CAUTION
► The Power Bank must never be charged and
used for charging an external device at the
same time.
► Due to the high battery capacity and bearing
in mind the charging time, the power bank must
be charged using a USB mains adapter.
► Use only a USB mains adapter with an output
voltage of 5V and an output current of at least
2.1A to charge the power bank.
► Use only the supplied charging cable
to
charge/discharge the power bank!
► Always disconnect the charging cable after
charging/discharging!
♦ Connect the USB plug of the charging cable
to a suitable USB power supply (not supplied).
♦ Connect the microUSB plug of the charging cable
to the microUSB charging port on the
Power Bank. An estimate of the charge level is
shown by means of the charge level LEDs .