SPB 3000 A1
■ 14
│
GB
│
IE
│
NI
Troubleshooting
The Power Bank does not charge
♦ Connection may be faulty. Check the connection.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
to start the charging
process.
♦ The charging current of the connected device is
too low (< 60 mA) or too high (> 2,1 A).
♦ The internal overcurrent protection may have
been triggered. Disconnect the attached device
and connect the microUSB charging port
to
a power source for a short while (see section
Charging the Power Bank). Afterwards, the
Power Bank can be used again.
NOTE
► If you cannot solve the problem with the
above-mentioned solutions, please contact the
Service Hotline (see chapter entitled Service).
To Next Page