SPB 5.000 B1
GB│IE│NI │ 9 ■
♦ During the charging process, the current Power Bank
charge level is shown via the charge level LEDs
(see table in section entitled Checking the charge level).
♦ Press the ON/OFF button
twice briefly to stop the
charging process and switch off the power bank.
The charge level LEDs
go out.
♦ Disconnecting the corresponding plug from the mobile
device.
Troubleshooting
The power bank does not charge.
♦ The connection may be faulty. Check the connection.
A connected device does not charge.
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
once briefly to start the
charging process.
♦ The charging current of the connected device is too low
(< 50 mA) or too high (> 2.1 A).
♦ The internal overcurrent protection may have been triggered.
Disconnect the attached device and connect the micro USB
charging port
to a power source for a short while (see
section Charging the power bank).
Afterwards, the power bank can be used again.
NOTE
► If you cannot solve the problem with the above-mentioned
solutions, please contact the Service Hotline (see section
Service).
To Next Page
Loading...
