23 GB/IE/NI
Step 2: Press the Up button
5
to set the sensitivity of the VOX function.
The higher the set value the more sensitive the VOX function will become.
You can set a value from “1“ to “3“.
Step 3: To deactivate the VOX set the value to “0“.
Step 4: Press the PTT button
14
to confirm the setting.
NOTE: It would be preferably to use this function in combination with
a headset. Keep in mind that it can take over a second after you have
started talking before the handheld transceiver starts transmitting.
Channel scan
Use this function to scan all active channels (1-16) in the loop.
Step 1: Briefly press the button
7
to start scanning
Step 2: Briefly press the Up button
5
or Down button
8
to continue
scanning if you are only receiving noise on certain channel.
Step 3: If the reception of the same channel keeps during the scan,
you may remove this channel from the scan by pressing and holding Up
button
5
or Down button
8
for 2 seconds. Then the scan will resume
but the selected channel will be skipped.
NOTE: You cannot remove a channel to which the walkie-talkie was
set when the scan was started. The next time you initiate a channel scan,
all channels will be scanned again.
Step 4: Press the Monitor/Channel Scan button
7
again to end the
scan.
Dual channel scan
Use the 2 channel scan to consecutively monitor the channel to which the
handheld transceiver is currently set and a 2nd channel.
Step 1: Press the Menu button
6
5 times and the “2CH“ icon
20
will
appear on the display
1
.
Step 2: Use the Up button
5
or the Down button
8
to select the 2nd
channel (‘OF’ means Off).
Step 3: Press the PTT button
14
to confirm.
Step 4: Repeat these instructions and select the option ‘OF’ in step 2 to
disable this function.
To Next Page
Loading...
