Scan Radio SR-1400
32 - English
To switch to a different station, press the SCAN
button (7) again. The next available station will be
searched for.
The scan is always performed up to the end of
the frequency band. To launch a scan from the
beginning of the frequency band, press the
RESET button (8).
Each time you power on the device, it will start
scanning for a broadcasting station from the
beginning of the frequency band. The last tuned-in
station will not be saved.
The technical details about the frequency band only
describe the technical characteristics of your device.
Different national regulations may apply in different
countries regarding the frequency bands that are
free for public use. Any information received from
frequency bands located outside those that are
explicitly free for public use may not be used, nor
may its contents be forwarded to any third parties.
To Next Page
Loading...