Scan Radio SR-1400
English - 31
Keep the SET button (11) pressed. Then press
the MINUTE button (9) repeatedly to set the
minutes. You can also keep the MINUTE button
(9) pressed down to accelerate the digit
adjustment.
Release the SET button (11) after the clock has
been set correctly.
Powering On and Adjusting the Volume
Rotate the volume adjustment knob (6)
clockwise, to power the radio on. This will adjust
the audio volume at the same time. Turn the
volume adjustment knob clockwise to increase
the sound volume, or turn it counter-clockwise to
lower the volume.
Turning the volume adjustment knob counter-
clockwise as far as it goes will power the device
off.
Tuning a Radio Station
When using the radio while it is inserted into the
docking station, please fully extend the telescopic
antenna.
Use the volume adjustment button (6) to set the
desired sound volume.
Press the SCAN button (7) to launch an
automatic station search. As soon as a station
has been found, the scan will stop and the radio
programme can be listened to.
To Next Page
Loading...