Silvercrest SRD 600 B1 - Initial Use; Mains Operation; Battery Mode

SilverCrest SRD 600 B1
12 - English
7. Initial use
WARNING! Use the shaver solely for dry shaving.
The shaver can be operated using batteries or as a mains-powered device.
7.1 Mains operation
Proceed as follows to use the shaver in mains operation:
 Connect the plug of the mains adapter to the charge connection [9] on the bottom of the shaver.
 Insert the mains adapter into an easily accessible power socket.
 Use the shaver as described in the next chapter.
 Following use, disconnect the mains adapter from the power socket and the shaver.
7.2 Battery mode
Proceed as follows to use the shaver in battery mode:
 Remove the protective cover.
 Press the on/off button [3] in order to switch on the shaver.
 The charging indicator [4] is shown during operation. If the battery drops to 10%, the charging
indicator [4] starts to flash.
 Use gentle pressure and circular motions to guide the shaver across your skin. Always hold the shaver
at a right angle to your skin. You can also tense your skin with your free hand in order to tilt the hair
on your beard.
Please note that shaving may result in a slight reddening or irritation of the skin. This is entirely
normal, as skin needs to adapt to this kind of shaving. It may take two to three weeks for skin to
adapt to this kind of shaving.
 Switch the shaver off following shaving by pressing the on/off button [3].
 Clean the shaver as described in the section “8.1 Cleaning”.