Silvercrest SRD 600 B1 - Cleaning;Maintenance; Routine and Thorough Cleaning

SilverCrest SRD 600 B1
14 - English
8. Cleaning/maintenance
8.1 Cleaning
DANGER! Disconnect the shaver from the mains prior to cleaning, otherwise there is a risk of
electric shock!
DANGER! Switch off the shaver prior to cleaning in order to avoid hazards.
DANGER! Never immerse the shaver in water or any other liquid.
WARNING! Do not use any compressed air, scouring pads or aggressive detergents to clean
the shaver.
We recommend cleaning the shaver following each use in order to ensure optimum shaving results.
Clean the housing of the shaver with a soft, damp cloth.
8.1.1 Cleaning after each use
Cleaning the cutter system
 Remove the protective cover.
 Clean the shaver heads of the cutter [1] with the cleaning brush provided.
 Press the unlock button [2] in order to open the cutter system. CAUTION! The cutter system [1]
cannot be removed.
 Clean the inside of the cutter [1] and the collection chamber with the cleaning brush provided.
 Fold in the cutter system [1] until you hear it click into place.
 Place the protective cover [1] back on the cutter system. Ensure that the wide tab of the protective
cover is aligned above the unlock button [2].
Cleaning the cutter
 Unfold the cutter [8] by pressing the tab of the cutter [8] and pushing this upwards.
 Then clean the cutter [8] with the cleaning brush provided.
 Apply a drop of sewing machine oil to the cutter [8] around every six months.
 Fold in the cutter [8] by pressing the tab of the cutter [8] and pushing this downwards.