Silvercrest SRD 600 B1 - Using the Cutter; Travel Safety Lock

SilverCrest SRD 600 B1
English - 13
7.3 Using the cutter
You can trim longer beard hair or sideburns using the cutter [8]. To use the cutter [8], proceed as
follows:
 Unfold the cutter [8] by pressing the tab of the cutter [8] and
pushing this upwards.
 Press the on/off button [3] in order to switch on the shaver.
 Switch the shaver off following use by pressing the on/off button [3].
 Clean the cutter [8] with the cleaning brush.
 Fold in the cutter [8] by pressing the tab of the cutter [8] and
pushing this downwards.
7.4 Travel safety lock
Switch on the travel safety lock [5] in order to prevent accidental switch-on of the shaver. Proceed as
follows:
 Press the on/off button [3] until the symbol for the travel safety lock [5] flashes.
 If the on/off button [3] is now pressed, the symbol for the travel safety lock [5] now flashes a few
times. The shaver will however not switch on.
Switch the travel safety lock [5] off as follows:
 Press the on/off button [3] until the shaver switches on. The symbol for the travel safety lock [5] flashes
a few times during this time and then goes out.
 The shaver can now be switched on and off with the on/off button [3].