Silvercrest SRW 250 A1 - Display Brightness

SRW 250 A1 Alarm Clock Radio
English - 125
While the sleep timer countdown is running, you can
power the device off at any time by pressing the
ON/OFF button [2].
Press the SNOOZE/SLEEP button [9] while the sleep
timer is enabled to display the remaining time until the
unit powers off.
Display Brightness
The display is set to maximum brightness on delivery. To adjust the display
brightness, proceed as follows:
 Press the TIME/DIMMER button [1] quickly to dim the display. “L”
(LOW) is shown briefly on the display [10].
 Quickly press the TIME/DIMMER button [1] again to dim the display
brightness automatically as a function of the ambient lighting. The
lightning conditions are measured by the light sensor [11]. “A”
(AUTOMATIC) is briefly shown on the display [10].
 Briefly press the TIME/DIMMER button [1] once again to set the
display brightness back to maximum. “H” (HIGH) is briefly shown on
the display [10].
 Pressing the TIME/DIMMER [1] button again allows you to repeat the
display brightness setting in the above sequence.