Silvercrest SSB 70 C3 - Volume and Audio Settings; Adjusting the Volume; Muting the Sound; Adjusting Treble and Bass

SSB 70 C3
24 - English
Control functions available in “USB” mode:
Action Function
Press the button (16).
Pause / Resume current track.
Press the button (16) if playback was previously paused with
the button (18).
Resume playback at beginning of last folder played.
Briefly press the button (17).
Skip to next track.
Press and hold the button (17).
Skip to 1st track of next folder.
Briefly press the button (30).
Skip to previous track.
Press and hold the button (30).
Skip to 1st track of previous folder.
Press the button (18).
Pause playback, playback continues with the first track in the last folder
played when the button (16) is pressed.
Press the button (18) twice in quick succession.
Skip to 1st track of 1st folder.
Pressing the button (28) repeats the track currently being played (display shows “ON”) or repeats all tracks stored on the storage device (display shows
“AL”).
LED display Function
ON
Repeats the current track.
AL
Repeats all tracks.
CAUTION! The USB port (4) must not be used to charge external devices.
9.3.5 “AUX” mode
Use this mode to connect a playback device with a Cinch output, e.g. a DVD player or satellite receiver. Use the adapter cable provided (E).
• Connect the Cinch output from your playback device to the AUX jack (11) on the sound bar.
• Switch the sound bar on using the standby button (2, 35).
• Press the “AUX” button (34) on the remote control to select this mode.
• You can use the volume buttons (29, 31) to adjust the volume to your requirements.
•
If you wish, you can change the audio settings using the relevant buttons on the remote control.
9.4 Volume and audio settings
Any changes to the volume and audio settings are shown on the LED display (1) for approx. 2 seconds. The display then reverts back to
the standard display for the relevant mode.
9.4.1 Adjusting the volume
You can adjust the volume during playback using the volume buttons (29, 31) on the remote control. Alternatively, you can use the volume buttons (3, 5) on the
sound bar. You can also hold the buttons down the change the setting more quickly. The volume selected is shown on the LED display (1) for approx. 2 seconds.
If you set the volume to the lowest level, “V 00” flashes continuously on the LED display (1).
9.4.2 Muting the sound
Press the button (12) to mute the sound temporarily.
9.4.3 Adjusting the treble and bass
You can adjust the treble to your requirements using the TREBLE+ (19) and TREBLE- (27) buttons.
To adjust the bass, press the BASS+ (20) and BASS- (26) buttons.