GB
│
IE
│
NI
│
CY
│
7 ■
SSC 200 A1
Preparations
Before first use
Before the first use, you should thoroughly clean all parts to remove any produc-
tion residues. Proceed as described below:
Ƈ Clean all parts as described in the section "Cleaning".
Ƈ Place the appliance base 3 on a level, stable and heat-resistant surface
close to an easily accessible power outlet.
Ƈ Insert the ceramic pot 2 into the appliance base 3.
Ƈ Make sure that the dial is set to “
” and plug the power plug into a wall
outlet.
Ƈ Fill the ceramic pot 2 with 0.5 litres of water.
Ƈ Place the glass lid 1 on the ceramic pot 2.
Ƈ Set the dial 5 to "
". The control lamp 4 lights up, the appliance starts to
heat up.
NOTE
► During initial use, a small amount of smoke and a slight odour may occur
due to production residue. This is normal and dissipates after a short time.
Ensure sufficient ventilation, for example, by opening a window.
Ƈ Switch off the appliance after 60 minutes by turning the dial 5 back to "
".
Ƈ Remove the plug from the mains power socket.
Ƈ Allow the appliance to cool down sufficiently, pour the water away and clean
all parts again as described in the section "Cleaning".
Setting up the appliance
NOTE
► If you are using the appliance for the first time, proceed as described in the
section "Before first use".
Ƈ Place the appliance base 3 on a level, stable and heat-resistant surface
close to an easily accessible power outlet.
Ƈ Insert the ceramic pot 2 into the appliance base 3.
Ƈ Make sure that the dial is set to "
" and plug the power plug into a wall
outlet.
The appliance is now ready for use.
IB_336973_SSC200A1_LB6.indb 7 08.07.2020 16:32:15
To Next Page
Loading...
