11
GB/CY
Place the drive unit
4
on an even, stable
surface�
Place the blender jug
7
on the drive unit�
Turn the blender jug
7
clockwise until it
locks into place�
Add the ingredients into the blender jug
7
�
Place the lid
2
on the blender jug
7
and
turn it clockwise until it audibly locks into
place�
Insert the lid plug
1
into the lid
2
� Insert
the mains plug into a socket that has been
correctly installed� Observe the
requirements in the chapter “Technical
data” and on the identication plate.
Turn the control knob
5
to “P” (pulse
function)
11
or “1”
9
�
For continuous blending, start at “1”
9
and increase it to “2”
10
after a short
blending time if necessary�
Switch the product off for at least 10
minutes after 3 minutes of continuous
operation�
If you want to subsequently add ne herbs/
spices or liquids, turn the knob to “0”
8
and wait until the blender comes to a halt�
Unplug the mains plug from the power
outlet�
Now open the lid plug
1
, add the
blending ingredients and reinsert the lid
plug�
Reconnect the mains plug to the power
outlet and turn the control knob
5
to “P”
(pulse function)
11
or “1”
9
to continue
the blending process�
If you want to subsequently add larger
pieces or foodstuffs, turn the knob to “0”
8
and wait until the blender comes to a
halt�
Unplug the mains plug from the power
outlet�
Turn the lid
2
and lift it off the blender
jug, then add the blending ingredients and
close the lid again�
Reconnect the mains plug to the power
outlet and turn the control knob
5
to “P”
(pulse function)
11
or “1”
9
to continue
the blending process�
Pour the nished mixture into a suitable
container�
z Cleaning and care
CAUTION! Risk of electric
shock!
Moisture in the product can
lead to short circuit and electric
shock�
Always unplug the mains plug from the
socket before cleaning the product�
The drive unit
4
must not be immersed in
water or any other liquids, or held under
running water�
Ensure that no water or other uids can
enter the housing�
Dry the product thoroughly before using it
again after cleaning�
CAUTION! Risk of damage!
Improper handling of the product
may result in damage to the
product�
Do not use aggressive cleaning agents,
brushes with metal or nylon bristles, or any
sharp or metallic cleaning implements such
as knives, hard spatulas or similar objects�
These may damage surfaces�
Regularly inspect the product for soiling�
Remove any dirt to ensure the product
works correctly�
Never put the drive unit
4
in the
dishwasher� It would be destroyed�
Cleaning
Wipe down the drive unit
4
with a slightly
moistened cloth�
You can wash the blender jug
7
and the
lids in the dishwasher (max. 65 °C) or by
hand with a mild detergent�
Allow all parts of the product to dry
completely after cleaning�
To Next Page
Loading...
Need help?
General
