Silvercrest SSM 600 B2 - Page 17

■ 14
│
GB
│
IE
│
NI
│
CY
SSM 600 B2
■ To remove stubborn dirt, you can remove the lower plastic part of the blend-
er 3 with the cutting blade 4 from the upper plastic part of the blender 3:
A
C
B
Fig. 3
A upper plastic part
B blade
C lower plastic part
1) Remove the blender 3 from the motor block 6. To ensure improved stability,
remove the lid 2 by rotating it anticlockwise towards position
(see Fig 1)
until you can pull it upwards.
2) Turn the appliance upside down and turn the lower plastic part C of the
blender 3 anticlockwise so that it can be removed from the upper plastic part
A of the blender 3 (see fig. 3).
WARNING! RISK OF INJURY!
► Always handle the blades B carefully. They are very sharp.
Risk of injury!
3) Clean both parts thoroughly in a mild soap solution.
IB_296694_SSM600B2_LB6_.indb 14 07.12.17 09:25