GB
│
IE
│
NI
│
CY
│
13 ■
SSM 600 B2
Cleaning
RISK OF ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block 6 in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
► Never disassemble the cutting blades 4 and never reach into the blender 3.
The cutting blades 4 are extremely sharp!
CAUTION – PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
Cleaning the blender
■ To prevent injuring yourself on the cutting blades 4, clean the blender 3 only
with a long-handled washing-up brush.
■ Clean the measuring cap 1 and the lid 2 in mild soap solution. Ensure that
the rubber seal 9 is correctly fitted before using the lid 2 again.
NOTE
You can also clean the lid 2, the measuring cap 1 and the blender
3 with the cutting blade 4 in your dishwasher.
■ If you clean the blender directly after use, you can often achieve a satisfacto-
ry and hygienic level of cleaning by doing the following:
Fill the blender 3 with 750 ml of water and add a few drops of mild
detergent. Close the lid 2 and fit the blender 3 onto the motor block 6.
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades 4 churn through the water
at full speed.
Afterwards, rinse out the blender 3 with lots of clean water to ensure that
all detergent residues have been removed.
IB_296694_SSM600B2_LB6_.indb 13 07.12.17 09:25
To Next Page
Loading...
