EasyManua.ls Logo

Silvercrest SSVS 70 C3 - Assembly

Silvercrest SSVS 70 C3
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 GB
WEAR PROTECTIVE
GLOVES! Leaked or
damaged batteries/
rechargeable batteries
can cause burns on
contact with the skin.
Wear suitable protective
gloves at all times if such
an event occurs.
Only use the same type
of batteries/rechargeable
batteries. Do not mix used and
new batteries/rechargeable
batteries.
Remove batteries/
rechargeable batteries if the
product will not be used for a
longer period.
Risk of damage of the
product
Only use the specified type of
battery/rechargeable battery!
Insert batteries/rechargeable
batteries according to polarity
marks (+) and (–) on the
battery/rechargeable battery
and the product.
Use a dry lintfree cloth or
cotton swab to clean the
contacts on the battery/
rechargeable battery and
in the battery compartment
before inserting!
Remove exhausted batteries/
rechargeable batteries from
the product immediately and
safely dispose of them.
Remove rechargeable batteries
from the product before
charging.
Do not short‑circuit the supply
terminals.
Before use
Unpacking
o Remove the packaging. Check if the product
is damaged.
Assembly
Number of persons needed for assembly: 1 adult
Fig. Step
D
1. Loosen the locking screw for the motor unit[8] from the opening for the motor unit[].
2. Insert the motor unit[7] into the opening for the motor unit[].
3. Tighten the locking screw for the motor unit[8].