28 GB/IE/NI
Pairing the headphones with a
Bluetooth device
Hall Switch function (pairing headphones
automatically)
Open the lid of the charging/storage box
[9]. Both
headphones
[1] will be switched on and paired
automatically.
The indicator LED
[5] on the primary headphone flashes
red/ white.
The indicator LED on the secondary headphone flashes
white only.
This means that the secondary headphone is paired with
the primary headphone.
Alternative headphone pairing method
Remove the headphones from the charging ports
[].
When the headphones are ready to pair, the indicator LED
on the primary headphone flashes red/white.
NOTES:
If the headphones have already been paired to each other,
the secondary headphone is already connected to the
primary headphone and flashes white only.
A signal sounds once the headphones are paired to each
other.
To Next Page
Loading...
