EasyManuals Logo

Silvercrest SV 60 A2 User Manual

Silvercrest SV 60 A2
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
12 GB
WEAR PROTECTIVE
GLOVES!
Leaked or damaged batteries /
rechargeable batteries can cause
burns on contact with the skin.
Wear suitable protective gloves at
all times if such an event occurs.
In the event of a leakage of
batteries / rechargeable batteries,
immediately remove them from the
product to prevent damage.
Remove batteries / rechargeable
batteries if the product will not be
used for a longer period.
Risk of damage of the
product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (–) on the battery /
rechargeable battery and the
product.
Clean the contacts on the
battery / rechargeable battery
before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Before use
Unpacking
Remove the packaging. Check if all parts are
complete.
Inserting/Replacing the battery
For first time use, pull out the insulation strip from
the battery compartment
30
.
Open the battery compartment
30
by pulling out
the battery receptacle (located at the back of the
remote control
31
(Fig. H).
Remove the used battery if present.
Insert a button cell (type CR2025) into the
battery receptacle. The + polarity marking has to
point upwards.
Slide the battery receptacle back into the battery
compartment
30
.
Assembly
Fig. Step
A
NOTE: The following parts are for
transport only. After unpacking, remove
and discard these parts.
Security tube (located on the shaft of the
main unit
16
)
Security plug (located between rear grille
2
and blade
4
)
Unscrew the L-shaped bolt
10
. Remove the
washer
9
from the stand post
12
. Place
the stand post
12
on the round base
11
.
Fasten both parts with the washer
9
and the
L-shaped bolt
10
.
B
Extend the upper pole
14
to its maximum
length (refer to “Height adjustment”). Place
the main unit
16
on the upper pole
14
. Fasten
both parts with the locking knob
15
.
Remove the blade lock nut
5
from the shaft
of the main unit
16
, grille lock nut
3
from the
main unit
16
.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SV 60 A2 and is the answer not in the manual?

Silvercrest SV 60 A2 Specifications

General IconGeneral
BrandSilvercrest
ModelSV 60 A2
CategoryFan
LanguageEnglish

Related product manuals