Silvercrest SWDR 500 A1 - Manual Tuning and Fine Tuning

SilverCrest SWDR 500 A1
30 - English
Manually tuning a station
Besides the automatic station search, you can also tune in a station manually.
This allows you to also tune-in any weaker stations. Proceed as follows:
Briefly press the "TUNE-" (13) or "TUNE+" (11) button to increase or reduce
the frequency stepwise. These steps depends on the selected frequency band
and tuning spacing. Please also read the following chapter for different tuning
spacings.
Fine tuning
If you don't succeed to find a specific station, you can adjust the tuning spacing
to a finer setting (see the following table).
The procedure is as follows:
 In radio mode, press the "Mode" button (15) once.
 The display (6) shows the current frequency and above it the "STEP"
indication as well as the current tuning spacing.
 Press the "TUNE-" (13) or "TUNE+" (11) button to toggle between the
normal or fine tuning spacing. The setting will be saved automatically.
Frequency range Normal / fine tuning spacing
FM 100kHz/50 kHz
AM EU* 9 kHz/1 kHz
AM US* 10 kHz/1 kHz
SW 5 kHz/1 kHz
LW 9 kHz/1 kHz
*For medium wave (AM), the tuning spacing depends on the date format
setting (EU or US), as set in chapter "Setting the date and time".
Saving a station manually
You can save up to 100 stations or frequencies for each frequency band.
Proceed as follows: