SilverCrest SWV 733 A2
52 - English
WPS - Connect to the AP (Router mode)
This is the easiest way to establish a connection to the AP. First, check whether your end device supports
WPS. For further details, please read the operating instructions for your end device.
1. Press the WPS button (9) on the dual-band Wi-Fi range extender for at least 2 seconds. After you
have released the WPS button (9), the Power/WPS LED (4) will flash rapidly for approx. 2 minutes.
2. Within these 2 minutes, please press the connection button (WPS) on your end device. For further
details, please read the operating instructions for your end device.
To Next Page
Loading...
