Silvercrest SWV 733 B1 - Page 74

SilverCrest SWV 733 B1
72 - English
No wireless connection to Wi-Fi router
 The distance from the Wi-Fi router is too great. Reduce the distance.
No LAN connection
 Check whether the network cable is correctly inserted into the WAN/LAN socket (5) of the
Dual-Band Range Extender and into the LAN socket of your end device.
Connection with the WPS button fails (connection attempt with Wi-Fi router)
 Establish the connection with the WPS button once again.
 Reset the Dual-Band Range Extender to its original condition. To do so, press the Reset button
(3) for approx. 5 seconds with a sharp object and then release it again. The LEDs briefly go out
and the Dual-Band Range Extender now performs a reboot. The Dual-Band Range Extender
requires a certain amount of time (boot time) after it is switched on before initial use. Wait
approx. one minute before using the Dual-Band Range Extender. Establish the connection with
the WPS button once again.
 Eliminate sources of interference between the Dual-Band Range Extender and Wi-Fi router.
 The distance between the Dual-Band Range Extender and the Wi-Fi router is too great. Reduce
the distance.