SilverCrest SWV 733 B1
English - 73
The configuration menu of the Dual-Band Range Extender is not displayed.
The address https://repeater.setup was incorrectly set in the address bar of the Internet
browser, check and correct your entry.
The configuration of the Dual-Band Range Extender is defective. Reset the Dual-Band Range
Extender to its original condition. To do so, press the Reset button (3) for approx. 5 seconds
with a sharp object and then release it again. The LEDs briefly go out and the Dual-Band Range
Extender now performs a reboot. The Dual-Band Range Extender requires a certain amount of
time (boot time) after it is switched on before initial use. Wait approx. one minute before using
the Dual-Band Range Extender.
Please check whether the network connection between the end device and the Dual-Band
Range Extender has been properly established. Please note that following the configuration, the
network connection is cancelled in the menu. Your system requires a brief period of time to re-
establish the network connection.
Please reboot your computer/notebook. Re-establish the connection to the Dual-Band Range
Extender.
To Next Page
Loading...
