4. I n s t a l l a t i o n
1. Put the product to a proper location, according to the overall layout, the daylighting or artificial lightings
and operation condition of the salon's or the home. And keep it in the clean, dry and cool environment.
2. Open the packing carton to check if the product is intact and whether the accessories or spares are
complete. Please contact distributor or us if there's any problem.
3. Installation
Place the product to the proper position. Please note that it is unnecessary to install extra screw on
the floor to fasten the bed, because the original design has taken the stability into consideration.
But please ensure the product is placed on a firm and flat ground, so as to prevent any accident. If the
product rotates or slant due to rough ground, please adjust the four pieces of plastic feet (M10×30)
and nuts (M10) by hexagon open-end wrench, which are fasten on the bottom panel, so as to ensure
the product is stable.
4. Connect the plug of product with power supply properly. (As shown in the photo)
Shop tables & accessories at
To Next Page
Loading...