To Next PageTo Next Page
Need help?Do you have a question about the SilverStone STRIDER ESSENTIAL Series and is the answer not in the manual?
General| Series | STRIDER ESSENTIAL Series |
|---|---|
| Type | ATX |
| Modularity | Non-Modular |
| Cooling | 120mm fan |
| Warranty | 3 years |
| Form Factor | ATX |
| Dimensions | 150 mm (W) x 86 mm (H) x 140 mm (D) |
| Protection | Over Voltage Protection, Short Circuit Protection |
| Molex Connectors | 3 |
Covers normal operation output characteristics including voltage, load ranges, regulation, and ripple.
Explains the PSON# signal for remotely turning the power supply on/off, defining TTL levels.
Defines cross-regulation specifications for various output rails under different load conditions.
Explains the Power Good (PG-OK) signal, its assertion criteria, and deassertion.
Details the protection mechanisms including input protection (fuse) and output protections.
Specifies maximum allowable voltages for +5V, +12V, and +3.3V outputs to prevent damage.
Details latch-off behavior for +5V,+12V,+3.3V,-12V and auto-recovery for +5VSB on short circuit.
Describes the TTL compatible Power Good signal for orderly start-up and its timing characteristics.
Outlines product defects covered, limitations, and responsibilities under the warranty.
