Need help?Do you have a question about the Sim-Lab P1-X and is the answer not in the manual?
General| Material | Aluminum |
|---|---|
| Color | Black |
| Dimensions | 1400 mm x 580 mm |
| Included | mounting hardware |
| Adjustability | Steering wheel height and angle, pedal position and angle, seat position |
Learn how to properly insert slot-nuts into aluminum profiles for secure connections.
Instructions on safely breaking off tabs from corner brackets when needed.
List of required tools for building the Sim Lab P1-X cockpit.
Prepare the 1350mm profile by inserting slot nuts, ensuring correct orientation.
Prepare the 500mm profile by inserting slot nuts, ready for frame assembly.
Assemble the base frame using 500mm profiles and corner brackets with M8 x 16 bolts.
Install end-caps and rubber feet on the assembled frame structure.
Assemble the feet support plate with the threaded rod, nuts, and washers.
Securely mount the assembled leveling feet to the main cockpit frame.
Mount 500mm profiles vertically using corner brackets and slot-nuts.
Install 120x40 end-caps and attach vertical profiles to the structure.
Assemble the front mount structure including side plates and brackets.
Attach the prepared front mount assembly to the main cockpit frame.
Assemble the wheel deck, its side plates, and corner brackets.
Fasten the complete wheel deck assembly to the cockpit frame.
Prepare and assemble side mount base and profile holders.
Securely mount the side mount assemblies onto the main cockpit structure.
Prepare the left and right P1-X pedal plates for mounting.
Connect pedal tray components using M8 bolts and washers.
Assemble using 320mm profiles, sandwich plates, and corner brackets.
Assemble using 580mm profiles and corner brackets.
To Next Page
