CRYSTAL4-SH
User Guide
45
Setup
This menu section provides access to installation adjustments.
Projection
Selects the orientation of the projected image.
Press to select one the four preset orientation. Use arrow buttons to switch
between the four presets.
Front-Projection: this is the default selection. The image is projected straight on
the screen.
Rear-Desktop: when selected, the image will appear reversed
Front-Ceiling: when selected, the image will turn upside down
Rear-Ceiling: when selected, the image will appear reversed in upside down
position
Note: Rear-Desktop and Rear-Ceiling are to be used with a translucent screen.
Power Settings
Direct Power On: choose “On” to activate Direct Power mode. The projector will
automatically power on when AC power is supplied, without pressing the “Power”
key on the projector keypad or on the remote control.
Auto Power Off : sets the countdown timer interval. The countdown timer will
start when there is no signal being sent to the projector. The projector will
automatically power off when the countdown has finished (in minutes). Range
[0 .. 180], with minimum increments step of 5 minutes.
Sleep Timer : sets the countdown timer.
To Next Page
Loading...
