V
The machine should be placed in a flat and stable place, instead of somewhere prone to
shaking.
Please do not place the machine in high-temperature places where there is direct sunlight or
heating devices, places where water, oil and smoke can easily enter the machine, or places
where there is much dust and is moist.
Please do not place the machine in a poorly ventilated or enclosed place.
When the cabinet surface is sprayed with paint or other substances with organic solvent and
grease, the rubber pad of the base may have a slight chemical reaction with it, resulting in
slight corrosion on the cabinet surface. Therefore, we recommend that the user put protective
materials (such as cardboard or glass plate) on the cabinet first before placing the machine.
We recommend that two or more people load, unload and move the machine. When moving it,
please avoid shocks, and especially protect its light-emitting lens.
The engineering plastics, insulating varnish on the internal transformer and rubber parts used
for the shell of the newly purchased product will emit certain smell like newly purchased
furniture, and it becomes stronger when the temperature rises. The smell is determined by the
composition of materials. The material solutions we use fully meet national regulations on
environmental protection, so consumers can use them at ease. The smell will gradually
decrease and eventually disappear during the use of machine. Please keep the environment
ventilated.
The wired network antenna connected to the machine must be isolated from the protective
grounding; otherwise, it may cause fire and other accidents.
Do not block vents or place sundries on the machine to ensure good heat dissipation effect.
Do not place the machine in a narrow and enclosed space that is not conducive to air
circulation.
The installation is as shown in the figure. Leave a space around the machine for ventilation.
Top view
At a minimum, leave the amount of space shown in the diagram
below for this device to have proper ventilation.
To Next Page
