Simagic GT1 HUB User Manual
1
Before calibration, flip the toggle switch C key up to C green (parameter setting calibration
working mode)
2
Push down the V key toggle switch and hold it down (do not let go), at the same time, pull
each and every paddle ABCD twice (in any order separately), afterwhich release the V toggle
switch.
3
After completing the above operations, flip C green to middle position C Red ( for dual clutch
mode) or bottom position C blue ( for dual axis mode).
4
Complete the calibration.
* If the keys on the calibration page of the control program jump after calibration, Calibrate again.
To Next Page
Loading...