scorpION3 5200969 Rev 4 12
2.5 Air Assist (optional)
If the scorpION3 bar has Air Assist, the inlet fitting will be located on
the end of the bar with the fault output jack. This fitting is a ¼” quick
connect suitable for typical plastic tubing (1/4”OD polyethylene,
polyurethane, nylon, etc). To make connection with the fitting, insert
the tubing until it stops. To remove tubing from the fitting, depress
the collar on the fitting and pull the tubing out of the fitting.
Compressed air or nitrogen may be used, however, it must be
clean, dry and oil free. While the maximum allowable input pressure
is 700 kPa (100 psi), the recommended nominal operating pressure
is 200 kPa (30 psi).
To Next Page
Loading...