Set Temperature by Touch
You could set the required temperature easily by touching the digital display. The setting
temperature is from 35
℃
to 65
℃
, which can meet different water temperature requirements
with easy operation.
Multiple Safety Protection
This product has safety protections includes self‐check protection, flame‐out protection, over‐
heat protection, accidental power‐cut protection, fan breakdown protection, over electric load
protection, electric leakage protection, over wind pressure protection, over temperature
protection, timing protection etc.
Tips
The above conclusion comes from the safety protection test under lab experimental conditions. It
may be affected by the surroundings in actual using environment. Thus, please use the product in
proper conditions rather than using it devastatingly.
NOTE
The water used in the system must meet the manufacturer's requirements regarding pH,
conductivity, hardness, alkalinity, chloride concentration, inadequate values give rise to the
non‐provision of the guarantee, the values of the system fluid must be within those listed
below:
• The content of soluble salts will not exceed 500 mg/l.
• The conductivity must not exceed 650 μS/cm.
• The pH of the fluid, with a temperature of 20º, must be between a minimum of 6 and a
maximum of 8.
• The total hardness of the water must not exceed 30º F,
It is recommended to treat the water when the hardness of the fluid is higher than the
established limits, total hardness, salinity, high conductivity. (polyphosphates, softener, etc,)
To Next Page
Loading...
Need help?
General
