Simmons DA2110 - Quick Start: Audio Input Connections; Connecting Drum Modules and Sources; Using the Routing Switch

6
INPUTS
• Connect your electronic drum sound module’s audio outputs to the
1
INPUT 1 jacks on the amplifier rear panel
• Stereo Input: use 2 cables to connect to both the INPUT 1 LEFT(MONO) and RIGHT jacks
• Mono Input: use 1 cable to connect to the INPUT 1 LEFT(MONO) input jack only
• If you’d like to amplify additional sources, connect them to the remaining rear panel inputs, or the front panel aux input
ROUTING SWITCH
• If you are using a single DA2100 series amplifier, set the
2
rear panel switch to Mono
• For dual-amp stereo configuration, see Smart Stereo on the next page
DA2108 REAR PANEL
DA2110 REAR PANEL
DA2112 REAR PANEL
QUICK START: INPUT
1
2
2
2
1
1
21506756 Simmons DA2100 Series manual_REV.indd 621506756 Simmons DA2100 Series manual_REV.indd 6 6/14/21 10:55 PM6/14/21 10:55 PM