Safety Instructions
Ÿ Safety should be always in the first priority.
Ÿ Use this Propane Forge after reading these entire instructions for the proper and safe
operation.
Ÿ Always use this Propane Forge on a hard level non-combustible surface. This Propane Forge
is for outdoor use only. Do not use it where any kind of damage can happen. Keep fire
extinguisher nearby.
Ÿ This Propane Forge is for adult use only. Keep this away from children.
Ÿ Use fire retardant gloves & blacksmith tong for the operation with the work-piece.
Ÿ Wear appropriate clothes such as a leather apron. Wear goggles while watching fire of the
forge.
Ÿ Never leave a hot forge unattended, even if the fuel is shut off and be cautious of high
temperature of the forge parts immediately after forging session.
Ÿ Inspect your propane cylinder (especially the valve), your regulator (especially the connector
to the cylinder and its O-ring) and your burner (especially the hose). For any signs of problems
do not install or operate.
Ÿ Install the regulator by hand, without tools, until the nut (left-hand thread) is fully seated.
Immediately tighten the nut with a wrench. Do not over tighten the nut, as this will only ruin the
connectors.
Ÿ Always shut down the forge by turning off the fuel at the cylinder, then backing off the regulator
knob (as a safety precaution.)
Ÿ Once, Forging Session is finished, Remove the Regulator from the cylinder & take the cylinder
in outside area.
Ÿ Allow the forge to cool for at least half an hour before you leave the area. This is to prevent
accidental fires from going undetected.
www.simondstore.com Page 2 of 13
Ÿ Simond Store will not be responsible for any damage or injury caused by use
of Gas Forges.
To Next Page
Loading...