www.simondstore.com Page 10 of 13
Operating Instructions
1. Open the wing nut slightly at the top of PART B.
2. Open the outlet valve of propane gas cylinder. So gas will be flow though Regulator.
3. Regulator has monometer which shows gas flow rate.
4. Rotate knob of gas Regulator clockwise direction to open the gas flow. Set gas flow as per desired flame.
5. For Double Burner: One burner is directly connected & another burner has a gas inlet valve. Kindly close
this gas inlet valve. After ignition of first burner then open the gas inlet valve for firing of second burner (If
required).
6. Light up the Forge by using Lighter at the opening of the burner inside the Forge body.
7. Now adjust the gas flow using inlet valve and air flow using the wing nut to get the complete combustion of
gas and desired flame intensity.
8. Place the iron work-piece to be forged, inside the forge and under the flame using tong.
9. Remove work-piece once it is red hot and ready for shaping with the help of tong.
10. Close the gas outlet valve of the propane cylinder and wait until fire in the forge stops.
11. Remove the propane cylinder connections to the forge and place it away from forge.
12. Allow Forge to cool down to normal temperature before transferring it to other place (if required).
Burner Troubleshooting Solution
We found that many time issues occur because of burner chocking and
improper flame output. These kind of issues arise due to clogging of burner orifice. We
have worked on these issues and resolved it by improving design of burner. So you can
clean orifice or you can replace it by new one. So youdon't need to worry when you buy
Forge from Simond Store.
What problems you may face in “PROPANE GAS BURNER?”
Ÿ No Flame or Low Flame
Ÿ Low temperature
To Next Page
Loading...