6
INSTALLATION
The MINI EVO 2 engine must be fitted to the frame using its four elastic supports
"silent blocks", radial mounted, positioned on the support, which are a protection
for the electronic ignition.
During installation, some safety precautions must be made: remember that an
engine generates vibrations, even if very small, which can cause the loosening
and/or removal of screws or any other object. Therefore, to prevent any engine
components may cause damage to persons and/or property, make sure the engine
through a small steel cable. Components normally "made safe" are:
• The filter and the carburetor to the engine
• The springs and exhaust to the engine
• The engine itself to the frame, bypassing the silent blocks. In this case we will use
the "webbing" of synthetic fiber is particularly resistant to traction and tearing.
The mouth of the spherical muffler should be lubricated with grease resistant to
high temperatures (e.g. copper grease) before being implanted in the exhaust
manifold.
We recommend taking maximum care when carrying out these operations: in any
case, during the assembly phase the proper choices must be made by expert and
qualified personnel.
FUEL
The MINI 2 EVO engine is designed to operate with a gasoline/oil mixture.
We recommend using oil-based semi-synthetic that, although inferior to a pure
synthetic, remains mixed with gasoline in the tank for a longer period.
During the running-in stage, use an oil percentage of 3.5% and then move to 3%
once the stage has been completed.
The gasoline must have an octane number that is not lower than 95, in order to
avoid pre-ignition phenomena.
Carefully mix the fuel oil in a tank is appropriate and it is better, once mixed, to use
To Next Page
Loading...
Need help?
General
