2. FUEL AND OIL
The VICTOR 2 PLUS / Victor 2 Super engine uses unleaded or leaded petrol at least 96 octane
rating. The engine requires the petrol to be premixed with two-stroke oil.
STOP: Do not run the engine without ensuring that it is correctly loaded (e.g. propeller is mounted).
Fuel contamination can be a major cause of engine failure. Ensure that your fuel container is clean
inside before you use it to fill up with fuel or oil.
Filter all fuel that goes into the fuel container. Also use a filter when transferring fuel from fuel
container into the aircraft tanks. The Victor 2 Plus / Victor 2 Super engine is designed to run on
unleaded petrol or leaded petrol or avgas mixed with 2 Semi-synthetic Oil.
The Oil to be premixed with fuel must meet or exceed the specifications API, TC, JASO, FC.
It is recommended only to use a semi- synthetic 2-stroke oil like Bardahl VBA or equivalent.
Use of Semi- Synthetic Oil pre-mixed in the petrol / avgas will greatly reduce the buildup of carbon
deposits in the cylinder heads and pistons. This will increase your service intervals.
2.1 MIXING PROCEDURE:
Use a clean container of known volume.
Pour Oil into container.
Pour Fuel into the can using a fine mesh filters.
Close container cap firmly and shake container for a few moments so that the oil and fuel are mixed
properly.
To Next Page
Loading...
Need help?
General
