2120 Transponder Continuation Specification Sheet M-1202 (Figure 11)
The transponder continuation specification sheet is made up of three transponder specification worksheets. Each
of these worksheets defines the parameters of a single transponder; a set of these worksheets comes with each
group of transponders located in the same cabinet.
Note:
For easy reference, tape each worksheet next to its associated transponder in the transponder cabinet.
Each transponder specification worksheet describes a specific transponder. Look at the numbered areas on each
worksheet: these areas contain information that affects the transponder’s external wiring. For example, Area 1 on
each sheet lists the custom labels for each transponder Monitor Point. These custom labels identify the circuit that
is to be monitored. Therefore, when you are making connections to a transponder’s Monitor Points, you should refer
to that transponder’s worksheet to determine where each monitored circuit is connected.
Look at Area 2 on each worksheet. This area lists the custom labels for each transponder Control Point. The custom
labels identify the circuit that is to be controlled. Refer to the specific transponder worksheet to determine where
each controlled circuit is connected.
Area 5 on each worksheet described special notes or instructions relating to a specific transponder. Make sure you
check Area 5 on each worksheet to determine if special wiring is required for each transponder.
B Simplex
2120 TRANSPONDER CONTINUATIC
TRANSPONDER SPECIFICATION WORKSHEET
CARD’
IN SPECIFICATION SHEET
1 CHANNEL NO (1 21-
a 7
fw ALARM DIGITAL
7 TRANSPONDER NO 1,.63,-
TRANSIENT
SUPPRESSOR
0 0 2
DIGITAL CONTROL
TRANSPONDER TYPE ,PROD IDI 5 LOCAL MODE [CONTROL PTS, 0
CY E FIRE ALARM DIGiTAL CONTftOt
TRANSPONDER SPECIFICATION WORKSHEET
CHANNEL NO II 21-
TRANSPONDER NO ,I 631-
TRANSIENT SUPPRESSOR 0
TRANSPONDER TYPE ,PROD IDI 5 LOCAL MODE ,CONTROL PTS / 0
212070-m OR2120-9---
MON,lOR Pi PRI SENSE
CBE
lDENllFICATION 0 31 F , A , 5 , H PNRq “IN
CUSTOM LABELS
^ - _I
/I
cl 7 FIRE ALARM DIGITAL
MONITOR
Cl 2 MGITAL CONTROL
0 8 FIRE ALAAM DIBITAL CONTROL
TRANSPONDER SPECIFICATION WORKSHEET
2120 Transponder Continuation Specification Sheet
FIGURE 11
14
To Next Page
Loading...
