Simplex 2120 - 2120 Control by Event Specification Sheet M-L 205-L (Figure 16)

.
,
2120 Control By Event Specification Sheet M-l 205-l (Figure 16)
The control-by-event specification sheets are supplied with all 2120 systems that l!se control-by-event software.
These sheets describe BMUX reactions to specific system events. As such, they are not required during installation;
however, the sheets are needed for system checkout. Therefore, do not discard these sheets.
2120 CONTROL BY EVENT
SPECIFICATION SHEET
THIS SHEET USED TO IDENTIFY CONTROL BY EVENT
(SYSTEM RESET) 00162
,SEl.ECT ONE 0)
DETECTOR RESET 0 SIGNAL SILENCE 00161
0
STATUS COMMAND
MONITOR POINT 0 CENTER
0
‘SECURITY BYPASS
(USE MONITOR PT. 1-8) 0
A SEPARATE S
(FOR REFERENCE ONLY)
IDENTIFICATION
33FICATION SHEET IS REQUIRED FOR EACH CATEGORY SELECTED.
2120 Control By Event Specification Sheet
FIGURE 16
19
firealarmresources.com