To Next PageTo Next Page
Need help?Do you have a question about the Simplex P20 and is the answer not in the manual?
General| Model | P20 |
|---|---|
| Category | Water Pump |
| Manufacturer | Simplex |
| Power Source | Electric |
| Material | Cast Iron |
| Max Liquid Temperature | 60 °C |
| Protection Rating | IP44 |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Inlet/Outlet Size | 1 inch |
Always use the handle to carry the pump. Carrying the pump by the hose may damage the hose and/or the pump.
Always check product specifications regarding pressure ratings, and capacities. The system operating pressure must not exceed the pressure rating of the lowest rated component in the system.
NEVER set the relief valve to a higher pressure than the maximum rated pressure of the pump. Higher settings may result in equipment damage and/or personal injury.
Thread hose into pump outlet. Use Teflon tape or thread sealant on hose fitting, leaving first thread free.
Check all system fittings and connections to be sure they are tight and leak free. Never add extensions to pump handle.
Explains 2-stage flow operation. For specific models, manual shifting to high pressure stage may be required.
Instructions for closing release valve, operating pump, and opening release valve to retract cylinder.
Pumps with 4-way control valves are designed to operate double-acting cylinders.
Steps to remove air from the system for single-acting cylinders, including venting and extending/retracting.
Steps to remove air from the system for double-acting cylinders, including venting and cycling the cylinder.
Instructions on checking and adding oil to the pump reservoir, ensuring cylinders are retracted.
Use dust caps on couplers when disconnected to prevent dirt entrance and ensure pump longevity.
Lists common problems like cylinder not advancing or not holding pressure, with possible causes and solutions.
