25
en
Specifications
ENGINE:
Brand Briggs & Stratton
Model Series Snow Series
™
Gross Torque 8.0 T.P. @ 3060 rpm, OR
7.5 T.P. @ 3060 rpm
Type 4-Cycle - OHV
Displacement 12.5 cu in. (205 cc), OR
9.9 cu in. (163 cc)
Starting System Recoil Start and Remote 110 V Electric Start w/Cord
Alternator No
Oil Capacity 20 oz (0,59 L)
Engine Oil Synthetic 5W30
Fuel Tank Volume 3.0 qts (2,8 liters)
Spark Plug Gap 0.030 in. (0,76 mm)
Spark Plug Torque 180 lb-in (20,3 Nm)
Ignition System This spark plug ignition system complies with Canadian standard ICES-002.
AUGER/IMPELLER:
Clearing Width 22.0 in. (55,9 cm)
Intake Height 12.5 in. (32,0) cm)
Auger/Impeller Diameter 10.0 in. (25,4 cm)
Number of Impeller Blades 2
CHUTE:
Chute Deflector Manual
Chute Rotation Manual Rotation - 200°
DRIVE SYSTEM:
Drive Type Auger - Propelled
Drive Speeds N/A
Wheel Size 8.0 in. x 2.0 in. (20,3 cm x 5,1 cm)
Power Ratings
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive En-
gineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and
corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values
are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.com. Net power val-
ues are taken with exhaust and air cleaner installed whereas gross power values are collected without these attachments.
conditions and engine-to-engine variability. Given the wide array of products on which engines are placed, the gas engine
of factors including, but not limited to, the variety of engine components (air cleaner, exhaust, charging, cooling, carburetor,
fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine
variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power
for this Series engine.
To Next Page
Loading...
