13
STOPPING THE TRACTOR & ENGINE
1. Return the ground speed control(s) to neutral.
2. Disengage the PTO and wait for all moving parts to
stop.
3. Place the throttle control in the position specified in
the engine owner’s manual provided in the operator's
packet shipped with your tractor. Follow any recom-
mended stopping procedures.
4. Turn the ignition switch to OFF. Remove the key.
DRIVING THE TRACTOR
1. Sit in the seat and adjust the seat so that you can
comfortably reach all the controls and see the dash-
board display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see STARTING THE ENGINE).
5. Disengage the parking brake and release the brake
pedal.
6. Depress the forward ground speed control pedal to
travel forward. Release the pedal to stop. Note that
the further down the pedal is depressed the faster the
tractor will travel.
7. Stop the tractor by releasing the ground speed con-
trol pedals, setting the parking brake, and stopping
the engine (see STOPPING THE TRACTOR AND
ENGINE).
Operating the Tractor
DO NOT TOW TRACTOR
Towing the unit will cause transmission
damage. • Do not use another vehicle to
push or pull this unit. • Do not actuate the
transmission release valve lever while the
engine is running.
Figure 4. Transmission Release Lever & Fuel Tank
A. Fuel Tank Cap.
B. Transmission Release Lever
B
A
MOWING
1. Set the mower cutting height to the desired level and
set the gauge wheels to the appropriate position (if
equipped).
2. Engage the parking brake. Make sure the PTO
switch is disengaged.
3. Start the engine (see STARTING THE ENGINE).
4. Fully lower the mower using the attachment lift lever.
5. Set the throttle to FULL.
6. Engage the PTO (Mower Deck).
7. Begin mowing. See Section LC for tips on mowing
patterns, lawn care, and troubleshooting information.
8. When finished, shut off the PTO and raise the mower
using the attachment lift control lever.
9. Stop the engine (see STOPPING THE TRACTOR
AND ENGINE).
PUSHING THE TRACTOR BY HAND
1. Disengage the PTO and turn the engine off.
2. Pull the transmission release (B, Figure 4) back
approximately 2-1/2” (6 cm) to lock into released
position.
3. The tractor can now be pushed by hand.
To Next Page
Loading...
Need help?
General
