To Next PageTo Next PageWhy is my Simplicity Regent so hard to steer?
If your Simplicity Lawn Mower steers hard or handles poorly, improper tire inflation could be the cause. Refer to the Check Tire Pressure section for guidance.
What to do if Simplicity Regent cut is rough looking?
If the cut from your Simplicity Lawn Mower looks rough, ensure the engine speed is set to full throttle and that you are not moving too fast; slow down to improve the cut quality.
Why Simplicity Regent cut is uneven?
If your Simplicity Lawn Mower cut is uneven, it may not be leveled properly, which requires attention from an authorized dealer. It could also be caused by improperly inflated tractor tires; see the Check Tire Pressure section.
How to fix Simplicity Lawn Mower cut that is rough looking?
If your Simplicity Lawn Mower cut is rough looking, set the engine to full throttle and slow down your ground speed.
What to do if Simplicity Lawn Mower runs and drives, but mower will not drive?
To address a Simplicity Lawn Mower that won't drive the mower, ensure the PTO is engaged.
Why Simplicity Regent engine knocks?
If the Simplicity Lawn Mower engine is knocking, check the oil level and add oil if needed. You may be using the wrong grade of oil; consult the Oil Recommendations Chart.
What to do if Simplicity Regent will not raise?
If your Simplicity Lawn Mower will not raise, it may be due to the lift linkage not being properly attached or being damaged, which requires attention from an authorized dealer.
Why Simplicity Regent Lawn Mower has excessive mower vibration?
If your Simplicity Lawn Mower has excessive mower vibration, it may have another problem, which requires attention from an authorized dealer.
What to do if Simplicity Regent engine knocks?
If your Simplicity Lawn Mower engine is knocking, check the oil level and add oil as needed. It could also be due to using the wrong grade of oil; refer to the Engine Manual for the correct type.
Why Simplicity Lawn Mower engine starts hard or runs poorly?
If your Simplicity Lawn Mower engine starts hard or runs poorly, it could be due to a fuel mixture that is too rich. Try cleaning the air filter.
General| Engine Brand | Briggs & Stratton |
|---|---|
| Cutting Width | 42 inches |
| Transmission Type | Hydrostatic |
| Fuel Capacity | 3 gallons |
| Deck Type | Stamped Steel |
| Turning Radius | 18 inches |
| Cutting Height | 1.5 - 4 inches |
| Warranty | 3 years |
Outlines essential safety rules for general operation of the tractor and mower.
Provides critical safety guidelines for operating the tractor on slopes.
Provides an overview and illustration of tractor and mower controls.
Explains how to test the tractor's safety interlock systems for proper operation.
Lists general safety measures to follow before and during tractor operation.
Provides a step-by-step guide for starting the tractor engine safely.
Outlines the correct procedure for stopping the tractor and its engine.
Instructions for operating the tractor's drive system.
Steps and tips for operating the mower attachment.
A comprehensive schedule of maintenance tasks and their intervals.
Procedures for checking blade stopping time and safety interlock system functionality.
Procedures for removing, sharpening, balancing, and reinstalling mower blades.
An introduction to troubleshooting common tractor problems and their causes/remedies.
Lists common tractor symptoms, problems, and solutions for diagnosis.
Lists common mower cutting issues, problems, and solutions for diagnosis.
Steps to adjust the brake spring for proper brake function on hydro models.
Steps to adjust the brake cam and spring for proper brake function on gear models.
Details the procedure for adjusting the PTO clutch for proper belt tension.
Specific instructions for adjusting the idler pulley on 44-inch mower decks.
Procedure to verify that mower blades stop within five seconds after disengaging PTO.
Step-by-step guide for replacing the mower drive belt on 38-inch decks.
Step-by-step guide for replacing the mower drive belt on 44-inch decks.
