F-9
Front-to-back leveling
1. With the mower installed, place the tractor on a smooth,
level surface such as a concrete floor. Turn the front wheels
straight forward.
2. Disengage the PTO, engage the parking brake, shut the
engine off, and remove the key.
3. Check for bent blades and replace if necessary.
4. Place the mower deck in mid-cut position. Turn the
mower deck pulleys by hand until the right blade (C)
faces front-to-back.
5. Measure the distance from the ground (F) to the
front tip (E) and rear tip (G) of the right blade (C).
(procedure continues)
C
G
E
F
To Next Page
Loading...
