F-10
Front-to-back leveling
(continued)
6. Repeat steps 4 and 5 for the left blade (D).
The front tips (E) should be even with the rear tips (G)
or within 3 mm (1/8"). If not, proceed with steps 7 and 8.
7. To raise the front of the mower deck, loosen the front
nut (A) and turn the rear nut (B) against the bracket.
To lower the front of the mower deck, loosen the rear
nut (B) and tighten the front nut (A).
8. Re-check the blade measurements and tighten the
both nuts (A and B).
D
G
E
F
A
B
To Next Page
Loading...
