Simplicity Baron - Tractor Drive Belt Replacement

F-11
Tractor drive belt replacement
Remove old drive belt
1. Disengage the PTO, engage the parking brake, shut the
engine off, and remove the key. Remove the mower deck
and discharge tube.
2. Unplug the PTO clutch (A) electrical connector.
3. Remove the PTO clutch capscrew (B) and washers.
Remove the PTO clutch, drive pulley and key.
4. Remove the capscrew and locknut from the rear of
the drag link (D).
5. Loosen both idler assembly capscrews (C) and remove
the belt from the pulleys.
6. Loosen the front and rear frame idler pulleys (E and F) and
remove the belt from the pulleys.
7. Loosen the transmission belt guide and remove the belt
from the transmission pulley.
(procedure continues)
F
D
E
C
B
A