F-12
F
D
E
C
B
A
Tractor drive belt replacement
(continued)
Install new drive belt
8. Install the new drive belt on the transmission input pulley,
and route the belt through all idler pulleys (C, E and F).
9. Install the engine drive pulley, key, washers and PTO
clutch (A). Install the belt on the drive pulley.
10. Secure the PTO clutch (A) using the original hardware.
Tighten the PTO clutch capscrew (B) to 61-75 N.m
(45-55 ft. lbs.). Be sure the frame clutch anchor engages
the PTO clutch.
11. Tighten all idler pulley capscrews (C, E and F).
12. Reconnect the drag link (D) to the steering arm. Coat the
drag link capscrew with thread-locking compound and
tighten to 23-31 N.m (17-23 ft. lbs.).
13. Release the parking brake.
14. Adjust the transmission input pulley belt guide to within
2-3 mm (1/8"-1/16") of the belt.
To Next Page
Loading...
