H-3
Assemble grass catcher
(continued)
5. Hook the bottom of the bag onto the front frame (E).
6. Insert the shock studs (G) through the sides of the bag.
7. Bolt the rear vertical rods to the top frame (A).
8. Bolt the top frame to the front frame (C).
9. Connect the shock supports to the top frame (B).
10. Hook the sides of the bag onto the front frame (D).
11. Tighten all hardware.
12. Install the bottom support (F) outside (below) the bag.
13. Install six cover clamps (H) on the top frame in the
positions shown.
(procedure continues)
H
H
A
B
C
D
D
G
E
F
To Next Page
Loading...
