Simplicity Baron - Installing the Grass Catcher

H-5
Install grass catcher
1. Insert the catcher arms (B) through the tractor back
plate (C). Note that the swing latches (A) must be on the
inside of the arms.
2. Secure the catcher arms (D) to the frame using four
7/16-14 x 1" flange lock capscrews and flange locknuts (E).
Do not tighten the hardware at this time.
Catcher-to-tractor clearance adjustment is
accomplished through the catcher arms. When
initially installing, hold the arms up and tighten the
mounting hardware. If more catcher-to-tractor clearance is
needed, loosen the arms and slide them toward the bottom
of the mounting slot.
(procedure continues)
A
B
C
D
E