H-9
Install front wheels
If using an overhead hoist to lift the unit,
lift using only the front axle.
1. Using a floor jack or chain hoist, elevate the front of the
tractor and support with jackstands.
2. Lubricate the front spindles (A) with lithium grease.
3. Install the wheel (B) on the front spindle with the tire valve
facing in toward the tractor.
4. Secure the wheel with a 3/4" washer (C), hub cap
retainer (D) and retaining ring (E).
5. Install the hub cap (F).
6. Lower the tractor.
7. Reduce tire pressure to the levels shown below:
Front tires 83-104 kPa (12-15 psi)
Rear tires 41-55 kPa (6-8 psi)
A
B
C
D
E
F
To Next Page
Loading...
