H-8
Install rear wheels
If using an overhead hoist to lift the unit,
lift using only the back plate or catcher
support arms.
1. Remove the lag bolts (A) and straps securing the front and
rear axles to the bottom of the crate.
2. Using a floor jack or chain hoist, carefully elevate the rear
of the tractor and support with jackstands.
3. Lubricate the axle shaft with anti-seize lubricant or lithium
grease. Install large washers (C) and a spacer (D) as shown.
4. Install the rear wheel (E) and key (B).
5. Install the hub cap retainer (F), retaining ring (G) and
hub cap (H).
6. Lower the tractor.
A
B
C
E
F
G
H
D
To Next Page
Loading...
